The Molikpaq Rig Electrician observed one of the electric cables running from the power feed box to the drill floor smoking. Upon investigation, smoke was rising from a single spot on the cable tray and when cabling was disturbed, sparks and a small flame were observed. The cable was immediately unplugged at the feed box along with two further cables. The initial inspection showed a small hole approximately 2cm in diameter located on the surface of the cable due to welding slack. Learnings:

• Protect electrical cables from hot sources such as welding slack through fire blankets.
• After welding/gas torching work, check electrical cabling for damage and integrity.
• Test the ground fault protection on a 4 Yearly basis (Shell Standard)